پروگرامر و دیباگر ST-LINK V2 مخصوص تراشه های STM8 و STM32

ST-LINK V2 ابزار اصلی پروگرام و دیباگ محصولات STM32 و STM8 است که از سوی شرکت ST به بازار عرضه شده است . این پروگرامر از پروتکل های (SWIM) و اشکال زدایی سری JTAG / سریال (SWD) پشتیبانی می‌کند لذا علاوه بر میکروکنترلر های 32 بیتی سری های 8 بیتی ST را نیز پروگرام می کند . به همراه این پروگرامر کابل اتصال به کامپیوتر و سیم های رابط مختلف موجود است .

نکته : تمامی پروگرامر های موجود در بازار ایران نسخه های ، های کپی می باشند پروگرامر فوق نیز از این قاعده مستثنی نیست . این به دلیل قیمت پایین و نیز کرک بودن نرم افزار های مورد استفاده کاربران ایرانی است .

Introduction

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to providing the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 2500 VRMS. STM8 applications use the USB full speed interface to communicate with STMicroelectronic’s ST Visual Develop (STVD) or ST Visual Program (STVP) software. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

Feature

5 V power supplied by a USB connector
USB 2.0 full-speed compatible interface
USB Type-A to Mini-B cable provided
SWIM specific features:
1.65 V to 5.5 V application voltage support on the SWIM interface
SWIM low-speed and high-speed modes support
SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed
SWIM cable for connection to an application with an ERNI standard connectorVertical connector reference: 284697 or 214017Horizontal connector reference: 214012
SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector
JTAG/serial wire debug (SWD) specific features:
1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs
JTAG cable for connection to a standard JTAG 20-pin 2.54 mm pitch connector
JTAG support
SWD and serial wire viewer (SWV) communication support
Direct firmware update support (DFU)
Status LED blinking during the communication with the PC
Operating temperature from 0 °C to 50 °C
1000 Vrms high isolation voltage (ST-LINK/V2-ISOL only)